Hello! This is my first post. I am looking through the instructions and everything to make sure everything checks out, and one part has confused me. In the wiring diagram for my model (ST-1M) it says there should be two wires. In the wiring video for the same guitar it says there should be a black wire with two little wires coming out of it (if im not mistaken), and one yellow wire pre-soldered on the back of the volume pot. But in my build there are two yellow wires coming out of the back, and one single black wire without the smaller wires inside. I looked around but I dont see any mention of this setup online. Is this a newer configuration? Or did my kit come with a quirk? How should I wire it up? Thank you