Wiring Diagram for 2 pot and 3 way switch question

[NRich]

Hi all, i am half way through my first build, and just about to wire things up, but just wanted to check one thing.

With the wiring diagram for the 2 pot, 3 way switch suitable for ESPM-1, on the volume pot, the far left solder point, is this just the terminal grounded to the pot body?

Any help would be appreciated.

Cheers

[McCreed]

...on the volume pot, the far left solder point, is this just the terminal grounded to the pot body?

Yes, that is correct.
You can either bend the solder lug so it touches the pot casing and solder it, or you can solder a bit of wire to make the connection.

I use off-cut legs from caps & resistors as a jumper for this. It's not better one way or the other, it's just my method. A good clean solder joint is what's most important.

[NRich]

Cheers mate, your prompt reply is very much appreciated...