Page 3 of 3 FirstFirst 1 2 3
Results 21 to 23 of 23

Thread: Peavey 410TX Bass Cab.

  1. #21

  2. #22
    GAStronomist DrNomis_44's Avatar
    Join Date
    Dec 2014
    Location
    Darwin,NT Australia
    Posts
    5,263
    Quote Originally Posted by Simon Barden View Post
    That will be wheely good.

    Yeah,....in a round-about way (yes, pun fully, and shamelessly intended.....hahahaha), then I'll be able to go a rollin, rollin, rollin on a river.....sorry, couldn't resist.....hahahaha.....
    Last edited by DrNomis_44; 08-09-2021 at 02:55 PM.

  3. #23
    GAStronomist DrNomis_44's Avatar
    Join Date
    Dec 2014
    Location
    Darwin,NT Australia
    Posts
    5,263
    I think I have finally found some info on the stock speakers that were in my Peavey 410TX Bass Cab, found this webpage after doing some googling this afternoon:

    https://www.hifisoundconnection.com/...EY-PACKAGE-368


    Even gives a full list of all the specs of the speakers.


    These Eminence Retrobass 10 Inch speakers look like they may be a good substitute/replacement:

    https://thespeakerfactory.com.au/pro...=shopify_email


    I could even go with these, I'd end up with a 4 Ohm cab if I used four of these in a series-parallel wiring setup:
    https://thespeakerfactory.com.au/pro...=shopify_email


    My Fender Super Twin will work with a speaker load with a minimum impedance of 4 Ohms, I would then most likely get the maximum power output of the amp if I plugged it into the Peavey 410TX with four of the 4 Ohm Eminence Retrobass speakers in it.
    Last edited by DrNomis_44; 10-09-2021 at 04:28 PM.

Page 3 of 3 FirstFirst 1 2 3

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •