Build 1 has been put to the side in mild disgrace so I can contemplate it’s future , press on or sand back.... got the poly on with a coat every day this week. Had a couple of little runs near the edge. So wet sanded 1000, and went through......
So thought we’d start a harder build and see how that goes...
Going pretty well so far. Rubbed back 240 and tried to highlight the grain with metho-diluted fw prooftint black, tried a burst outline . rubbed back again at 240 then tried rustoleum barn red stain over the top. Not keen on this as it’s a bit sticky and yuck but I’ve been waiting a month so far for keda dyes so that’s what I could get ...
Neck sanded 240 and stained golden teak
Seems to look ok probably only downer is that the maple veneer on left half is obviously better than right half.
Sent from my iPhone using Tapatalk
Reply With Quote