Hi all,
Embarking on my first build. Thought I'd start simple, so I kicked on with an ST-1M. I just love the maple neck and fret board and the ash body gives plenty of scope for staining to great effect.
My aim with this first build is to perfect the basics and the important stuff, like getting the neck right and getting a handle on staining timber I'm not used to working with before going mad and immersing myself in a more complex build
So.........in the interest of getting off on the right foot;
I was doing a dry run build, getting familiar with the hardware etc that comes with the kit and that was gong along OK and then I started to look at the bridge, which prompted a couple of questions.
Can anyone advise how the bridge is actually assembled and installed? The lack of a simple diagram makes this h/ware a bit of a mystery to put together
Its has a tremlo and there are springs in the kit. I can't find any post or commentary in the forums on 'how-to' and none of the videos cover the ST-1 so any assistance here would be great.
Thanks in Advance
aj
"When sanity fails, reach for coffee"