I have opened the box, inventoried the parts and am ready to do the preliminary fit(s). Starting with the neck, I'll need to file or sand the sides of the neck to obtain a good fit. Just a wee bit snug, I'll have to remove only 0.001" or so from each side of the neck. I did notice that this fit appears to be a very slight dovetail.
I didn't see a scale length in the description, but believe it to be 24-3/4", as I measured from the inside face of the nut to the top center of the 12th fret to be 12-5/16", when doubled is 24-5/8".