Has anyone had problems with Grover Rotomatics breaking strings.
I installed and strung the Grovers yesterday for the first time.
Then I tried the new build and the middle pub was dead. Turned out to be a short with the copper foil. But that’s another story for the build diary.
Anyway I had to take the strings off so I could unscrew the scratch plate to check the wiring. I hadn’t cut the excess off.
When I unwound 4 of the Grovers they just released the strings and I pulled them out.
The other two broke the string at the Hole when then went back past at which they were loaded the point.
Has anyone had the same problem?
Maybe they were not designed to allow reuse of strings.