Hi.
Finished assembly of my ST 1. Only three wires to solder so what could possibly go wrong? Plugged into an amp and have no sound whatsoever. Yellow earth wire was soldered to the bridge as per video. The 2 black wires that go to the out put jack however were virtually the same except one wire had what looks like a dot of white or silver paint on it. So 1 went onto the outer lug and the other to the earth lug. I am hoping that as those wires were virtually identical I might need to simply un-solder them and swap them around?
The amp is fine and as the lead came with the kit I assume that it is fine too.
Any tips before I plug in the soldering iron.
Oh and yes, the amp was switched on.
Regards
Moley (Tasmania)