A bit better weather today; no rain, warmer and far less wind. But I'm feeling under it a bit, so am not planning on doing much today, apart from adding some more black paint to the headstock faces to build up the thickness.
But I did drill the bridge post ground wire holes. I didn't use a long drill bit as originally planned, as the longest bits I had were all to big for the job (fine for making larger control wire passages in bodies but not for a single thin wire), so I'd ordered a small pin vice drill that came with a whole assortment of very small drill bits (always very useful) that arrived today.
GSJ-1. You can just see the drill bit poking through at the bottom of the post hole:
GSM-1, showing the pin drill. Masking tape on the edge of the rout to prevent any damage from using the drill.
The GSJ-1 has had a coat of Heritage Cherry lacquer applied, whilst the GSM-1 is yet to have it, hence the difference in colours between the two bodies.