PRS-1Q by AxeMurderer

[ILRGuitars]

Looking great Axe. What grade paper did you use to sand back the base?

[stan]

Amazing burst

[AxeMurderer]

Looking great Axe. What grade paper did you use to sand back the base?

Thanks ILR. I originally went to 400 prior to dying then used both 240 and 320 to take the dye coat off. I think I had it too smooth to start with. Doing it again I'd stop at 320.

[Zandit75]

Great looking burst Axe!!

[Muzza]

That's a great burst. It gives me hope that I may yet salvage some pride with my first PRS build. (Now where did I put that pile of sandpaper?)

[FrankenWashie]

That's a great burst. It gives me hope that I may yet salvage some pride with my first PRS build. (Now where did I put that pile of sandpaper?)

Its always in the place you least expect it. Try the freezer.

[Muzza]

I was hoping the sanding part was over...

[FrankenWashie]

Oh Muzza....the sanding is never over.

[AxeMurderer]

A couple of coats of shellac sprayed on as a base for the oil finish.





Tonight we sand.


Sent from my iPhone using Tapatalk

[AxeMurderer]

Meanwhile, veneering and shaping the headstock.