Quote Originally Posted by wokkaboy View Post
Hi Amid, kit looks great other than the neck fit. Looks like you will need to sand down under the fingerboard around 20th fret to the end of the fingerboard. Draw a pencil line on both sides from the existing corner to the end of the fingerboard so the fingerboard will lye flat on the body, and that should eliminate the gap on the front of the body neck join.
Once you get the fingerboard sitting flat on the body then you may have to glue thin veneer on each side of the neck pocket to make it a tight fit.
Does that make sense ?
The first picture shows the underneath end of the fingerboard is too proud causing the gaps
Yeah i see except i think i may just have to start sanding where the perpendicular angle is (wich doesn t end perpendicular at all).
The other side just slide in the pocket so sanding won t help.