First Build - ES-12G

[gavinturner]

Hey John, looks like a great kit! Be very careful sanding the veneer - it's very thin and there's a good chance you'll sand through. When that happens it sucks the big one. Any chance you could post a picture of the "pits" in the surface? Maybe some steam might be a possibility to raise them out, but hard to say without looking at them.

cheers,
Gav.

[johnc]

HI Gavin,
Thanks for the reply. Pic attached, probably doesn't show it very well, actually it makes it look slightly worse than it is.
I spent maybe a 2-3 minutes sanding with each grit? I'm new to this whole sanding lark.
As i mentioned, the surface is very smooth, so maybe once I apply the stain etc. it won't be as noticeable?
Thanks again
John