Building Gavmiesters HB-4

[dingobass]

Now for the fun bitz...

here is a dent that would prove fatal if I tried to sand it out.

Solution? steam the bugger out.

For this process, I need a damp rag, pipette and soldering iron set to around 100 degrees C.
First I place a drop of water on the dent and let it soak.
Then with the damp rag I start to steam the area.

After few minutes, the dent is reduced by 50%, once the surrounding areas had dried out it was reduced even more.

Now I can sand it out without ripping through the cap.