I don't have an orbital or belt sander Wokka, the lines are only to guide, I will fix it all up as I go. I'll be using some files and rasps to do my carving, should be very fun!

So when I finish lunch I'll head out and go to the big green shed (sorry DB, but it's a lot easier if I do) to get the files, rasps, some timbermate, new drill bits and a clamp. Then just down the road to Altronics (like 500m away from Bunnings) to get a multimeter and finally off to Sky Music (again, just down the road) to get some new guitar leads...

Due to the jack plate being a bit close to the edges, I might not do the full bevel as planned, but I'll simple round the edges off with a small diameter, the other two carves will definitely go ahead as planned!