Wokkas Ash Strat - burning sun and jarrah stain burst

[rockmof]

HSH interesting, should be very nice.

[WeirdBits]

Wokka, is this what you wanted? I did it quickly but I think it's correct. Tonerider pickups, right? The dark blue wires are connecting to the white+black series links, and the light green wires are connecting to the green+bare wires.

The tone controls are linked to the neck and middle like a normal Strat, but if you want them on neck and bridge just swap the light blue wire to the other lug on the switch (the bare lug above the spring).

[wokkaboy]

cheers heaps Weirdy, yes spot on its for this build tonerider pups, you are an absolute champion, thanks again bro

[WeirdBits]

/<\\/p>[]<\\/p>/Quote from wokkaboy on October 15, 2014, 14:11
...So I only need one capacitor for tone ? I see you have them linked between push/pull pots
Also does it matter which side of the bank of 3 lugs on the push pull lugs I connect to ? all the diagrams supplied say left lugs and you connected on the right.
Sorry for all the questions but wiring/electronics are by far the weakest part of my builds !

One cap or two, it's up to you. With one cap the path to ground for both tone pots is through that single cap, which is why that orange wire links the pots. Two caps is good if you want to use different values for different pickups. If you want to use two caps just disconnect the orange wire between the pots and instead connect another cap to ground setup like on the other pot.

Each 'bank' or vertical set of three lugs on the push/pull switch is one 'pole', hence they are double pole double throw switches (DPDT, two pole with two positions). You can use either pole for the coil splitting, it was just easier for me to draw them on the right side in this case. Using the left is fine.

[wokkaboy]

cheers Weirdy that makes sense and what I thought, I must have learnt something about wiring after the 40 odd axes I've built. Thanks for clearning that up mate. I'll remove my questions from your build thread. So I've been using 2 caps all this time and really only needed one if using the same value !