hi guys,
Time for clear coats! With the memory of this build's last bitter failure still fresh in my mind, I have finally decided to steer well away from Polyurethane in any of its many forms. So too, since my success rate with spray on Acrylic Lacquer is still less than 100%, I'm also reticent to go down that path with the Tribute either.
So what am I left with? Well, for my very first build I actually had quite good success using Behlen spray on nitro. It was easy to apply, it didn't run, and it tacked off quite quickly. And since I don't have to wet sand the Pollock, it seems like a convenient and stress-free choice for me to take. I even have a couple of cans of the stuff lying around!
I'm going for a satin finish so should be easily achieved using just these 2 cans. At the end of the day, I'm only chucking it on for the protection! I have tried it on my "test" guitar and there foesn't seem to be any adverse reactions. Time to take the plunge.
cheers,
Gav.