The DB Pick-up Winder

[keloooe]

AHHHHHHHH!!!! ok then, so im guessing the power switch isn't in the diagram yet?

[Gavin1393]

You'd be guessing wrong!

The reverse switch is in the original schematics....

I just reproduced the wiring diag for you. I wanted effectively a kill switch which is what the front switch does.
I didn't need to install it. Also, the Red 'reset' switch was unnecessary as the counter had its own built in reset switch.

[keloooe]

ok, so can you please post the diagram for the on/off switch???

[Gavin1393]

/<\\/p>[/<\\/p>[]<\\/p>/]<\\/p>/Quote from keloooe on June 18, 2013, 13:36
ok, so can you please post the diagram for the on/off switch???

It's not needed and will possibly confuse folks. Plus if you really want a picture of an on off switch it can always be googled!

[keloooe]

is it similar to kill switch from a guitar???

[Gavin1393]

Here is a typical on/off switch.

[AJ]

my winder is basically finished now, only need to make/ get some guides for the shaft that I made up from a 6.5 mm steel rod. made short movie of it, but am having difficulty in uploading it from the phone now.. bugga!

[keloooe]

oh, that reminds me, where;s a good link to the hardware for the shaft that holds the bobbin holder, and also links to hardware for the traverse limiter???

[AJ]

https://dl.dropboxusercontent.com/u/.../VIDEO0015.mp4 bit rough, but show it running .

[Brendan]

Nicely done AJ - like it! What'd it end up setting you back?