Tele - single coil bridge - humbucker neck wiring

[fender3x]

Hello new member and new builder here . I have very limited knowledge when it comes to wiring . I tried to use your diagrams here but I am still having trouble . I have a lace alumitone humbucker in the neck position and a single coil in the bridge . I have a 4 way switch and a pushpull volume pot to spit the humbucker. I would like to have it wired as 1st position humbucker 2nd neck + bridge series 3rd neck+ bridge parallel 4th bridge. Was wondering if I could get any help with a wiaring diagram . I've searched the internet and had no luck specially since lace alumitone pickup is diffrent then normal when it comes to coil splitting. Any help or advice/ suggestions are appreciated

I didn't find a single wiring diagram, but the combination of these two should work. I found the Alumatone diagram on their website for a "DeathBucker" but their Humbucker seems to use the same wiring and color scheme.



Wire your pickups like in the diagram above. Attach the orange wire from the Alumatone to the switch to where the white wire from the neck pickup is attached in the diagram above.



A mini toggle switch like the one in the LACE diagram works just like one side of a push pull pot. So you are only going to use one column of contacts, let's say the right side. Wire the white wire from the Alumatone to the right post nearest the top of the switch. Wire the white/black wire to the bottom post on the right.

Wire the green wire on the Alumatone to the ground (eg. to the back of the pot). Wire a second green wire from the right-middle post of the switch to the ground (eg. to the back of the pot).

That should do it ;-)