Bridge holes in the wrong place is something that occasionally happens on the kits, but sometimes appearances can be deceptive.

Whilst the pickup routs look evenly spaced either side of the neck pocket, the mist important alignment is the bridge with the neck centreline.

I’d clamp the neck in position and fit the bridge temporarily using masking tape wrapped round the bridge studs (don’t fit the splined inserts, just remove the height adjusting posts and use them) so that the posts are held centred in the holes. Then put the bridge on top and run standard string or cotton over the bridge up to the nut for the two E string positions and see if they run evenly down the neck.

If not, take a photo, email Pit Bull and ask for a replacement kit. The necks are matched with the bodies so you need both replaced.

If they do, loosely fit the pickups and surrounds in their routs and see how they line up against the strings. You’ve normally got 1-2mm or so of sideways movement available here. It might all come together, or it might not. Again if not, photos and email Pit Bull fir a new kit, and get them to check it properly first.

The Chinese factory QA is pretty dire at the moment, but holes that are slightly out are difficult for Pit Bull to spot.