The Frankencaster

[Eponymous]

Ooooooo!!! Me want....

@Eponymous - Good work. It's a shame it cost you one body to get there, but you've got a good practical salvage plan!

As Frankie said, it certainly can go wrong even with a drill press (don't ask me how I know this ).
One trick to getting the ferrule holes in nice even line is: draw a parallel line off the centre line half the diameter of the hole size, then clamp a piece of hardwood (with a good square edge) along the line, then use it to plumb the edge of the drill bit to.

You still have the challenge of the centre to centre spacing, but the ferrules can be jigged around a bit to even up those little spaces if needed.

Look forward to seeing the rest of the build. Cheers

Great idea, McC! Brilliant, in fact! Excellent!

There now seems to be a problem with the dingotone finish not setting properly on the neck, so I haven’t done the drilling for that yet. Might have to get some white spirit or something to clean it off and start the neck finish again but that is a problem for tomorrow...it might set properly overnight but is has been 24 hours..

I know you guys haven’t used the dingotone finishes, so I will work this one out.

[FrankenWashie]

Great idea, McC! Brilliant, in fact! Excellent!

There now seems to be a problem with the dingotone finish not setting properly on the neck, so I haven’t done the drilling for that yet. Might have to get some white spirit or something to clean it off and start the neck finish again but that is a problem for tomorrow...it might set properly overnight but is has been 24 hours..

I know you guys haven’t used the dingotone finishes, so I will work this one out.

I used the Dingotone neck finish on my TLA-TH. Thin coats and many of, allow lots of drying time. I found it reasonable to use and it doesn’t bore into your skull though your nose like other finishes tend to.