AG neck Fit problems

[Jokermark]

Managed to dig up my AG build



This is how the neck ended up in mine.



Also, just be careful when glueing and clamping, You want to make sure there is enough break angle on the neck. If you clamp too hard on the tang of the neck you can greatly reduce that angle which will cause action problems later. Good contact at the heel is the most important.

You can check the break angle with any straight edge like this with the neck clamped.



Different guitar in that pic, but same principle - you want room to have the bridge posts wound out a bit so the bridge sits up off the body.

Thanks for the input, i may be ok but its gonna be close...