Stripping back is harder than I expected. Feels like the colour coats never really cured and the clear is kinda soft also (been well over a year since this was "finished"). Once I got below the clear, it just seemed to spread the colour around in patches.
Left it like this for a couple of days and hit it again. This time the rest of it came off a bit easier.
The back currently looks like blotchy pic above. Will give that until the weekend and get the rest off it then. Some of the tighter edge sections might be tricky. Don't want to hit it with any chemicals or heat gun if I can get away with it so will probably be a lot of manual sanding.
Reply With Quote