Well it's been a while since my last post, been playing with my new toy an evh Wolfgang. Nice axe and my new standard of playing excellence.
Ok so here goes.
Body laminates are on, neck pocket routed, neck roughed out and joiner shoe is set. Scale length has been measured and neck alignment is set. Fretboard has been measured to length but rebate set and frets preslotted with a .01mm saw prior to inlay and slotting to depth with a .05mm fret saw. I find doing it this way I can run my micrometre along each consecutive slot and mark the next fret.
Inlay comes next. Maltese Cross paua shell .
Reply With Quote