Build #2 - Doublecut custom

[wazkelly]

Bit late on the scene but reckon that looks pretty good as is and wouldn't contemplate a burst if you have never done one before.

The lighter parts on top LHS of above shot are similar to area near lower bridge post location plus around PUP cavity. From a distance it would be very hard to pick.

As for the finish, need to take your time with DT to allow proper curing and CG intensifier coats will make a difference. Maybe 2 intensifier coats might be enough as you don't want too much of a thickness as that could cause grief when doing top coats and final polish.

Cheers, Waz

[SamSquare]

Bit late on the scene but reckon that looks pretty good as is and wouldn't contemplate a burst if you have never done one before.

Hmm... thanks for the balance! I was getting geared up to try the burst but it is looking better with each coat and I don’t want to ruin it. That tele over on that other thread did give me some confidence too...

I’m away on holiday in a week so I think I’ll defer that decision till I get back...


Sent from my iPhone using Tapatalk