I have a few new questions.
Hi guys,
just doing a dry build to see what's what.
Found the neck scale length a few mm out.
Found the neck to bridge, well, I don't know where to begin given the cavity for the bridge has about 10mm play in it.
I found a slight gap in the neck socket of 1 or 2 mm I thought this may need sanding the neck pocket so it sits flush? or just leave it?
These images show the bridge in its most forward position and the most rear position in being measured form the 12th fret.
Also the small gap in the neck pocket and the measurement on the 12th from the inside face of the nut.
Reply With Quote
