Things are moving very slowly in Sonic Mountain land due to life getting in the way. Have done a little more on this, at least its getting plenty of drying time. Managed to give the frets going over today. The wear was pretty bad so a lot of material needed to come off. I'm reasonably happy, but might give it a bit of a tidy up again after finishing.

This is after putting some posca across the frets and doing a very light level. You can clearly see the divots, it got a decent playing in it's heyday.



I thought this pic was better than it is.. anyway after using the radius block to get them level I go back over with the file until to two edges of the flat bit I've create just meet





Then back over with steel wool and polish using the dremel

Then a really good steam clean to get rid of all the finger gunk



Then some oil