My First Build - TLA-1

[supapuffin]

Two coats of sanding sealer have been applied. Now the serious sanding can begin.

[I’ll give it a go]

Two coats of sanding sealer have been applied. Now the serious sanding can begin.

Have you found when sanding the sealer that the heat from the friction when sanding seems to melt or I go like a wax?


Sent from my iPhone using Tapatalk

[supapuffin]

Have you found when sanding the sealer that the heat from the friction when sanding seems to melt or I go like a wax?


Sent from my iPhone using Tapatalk

I sure did. I noticed it flaked off the paper fairly easily but I think I went through paper faster than usual when cutting through the initial layer - it would clog up pretty fast.

I suppose that when this is used in more typical cases it would get cut back with 80 grit paper using a sander so would not be as noticeable.