Woltz's TLA-1Q

[Woltz]

However many layers you put on, there's always going to be a bump as it will follow the contours of the decal, so add enough layers to be sure that the surrounding area is several layers higher than the decal surface. Always be very gentle when fine sanding/polishing over the decal area.

Thanks Simon, what would you normally sand/polish with once there are a few layers on. I have fine grit sandpaper or I could just go straight to the meguiars polish that I'm using on the body?

Looking great 👍🏻

I really like the new binding

Thanks mate, as much as this kit has been a bit of a nightmare at times, the change from white binding to the pearl I'm really happy with.