Day 6: Part 3
Over to another bench to route out the binding channel top and bottom.


Next step is carving out a spot for the end wedge.

This is purely a decorative piece to cover up the join where the two side pieces meet. This was my second attempt after I mis-sanded the middle piece by less than 0.5mm!


Still a dry run to go over my options for how this section would all meet up. I had in mind to miter all of the corners to have it all flow together seemlessly, but I don't have the time to attempt that!


Glued in place.


Sent from my SM-G930F using Tapatalk