Quote Originally Posted by wazkelly View Post
Wired up the DPDT mini switch earlier tonight and that works & sounds best out of all the combinations tried so far.

Thanks guys for all your ideas, guidance & assistance.

Next job is to dig a bit more timber out in the control plate cavity as there is a square plastic terminal block for belcat pre-amp with lots of wires coming and going that is preventing everything fitting in an already cramped space. Don't own a dremel and not keen spending the coin for just this one job. Might have to use a chisel instead unless someone has a bright idea for cutting/recessing at 90 degrees inside a 30mm wide trench which is just on 38mm deep?

For it it sit vertical, thickness is about 6 or 7mm thick whilst horizontally I would need to go about 18 to 20mm deep and drilling in via jack socket hole seems most logical way to go? Will ponder this for a few days before attacking it.
Waz,

I have a green shed brand dremel style tool....with a flexible extension....and heaps of fittings.

I am at work....residential care in a community home in Bells Reach.

I am supposed to finish sometime Friday.

I will be home over the weekend....either drop in and grind away...it is permanently setup on my desk....or come borrow the machine.

I only use the sanding attachments...no idea what the rest do. 😎