Thanks @nitroburner1000 I was able to sand out most of the glue marks and restrain to make them barely noticeable. Thanks for your help.



Top and binding masked and ready for spraying. I have no idea what this will turn out like but I am going for a bit of a strange colour combo. Maybe someone can input here but I am spray a few coats of sanding sealer on but as it is ash it is soaking it all up. I will be spraying nitro on top but would still like to see a bit of the grain pattern BUT would also like the finish to be flat. Would I be able to put sanding sealer on top of the colour once it’s cured and then lacquer to get it flat...I have no idea what I’m doing




Sent from my iPad using Tapatalk