FrankenWashie's Second PBG Build, SV-1

[FrankenWashie]

Yeah I went there initially wth the three springs Wayne, but it just felt wrong and the instability it caused was unworkable.
it sits angled slightly back now so I figure when I change up to the heavier gauge set it will pull it up a bit harder.
The nut is a pain and even a moderate tension on the locking screws caused a strip. Will pull it apart and see what can be done with it, I’ll persist with it until it pees me off enough to change it out completely.

[Andyxlh]

Yeah I went there initially wth the three springs Wayne, but it just felt wrong and the instability it caused was unworkable.
it sits angled slightly back now so I figure when I change up to the heavier gauge set it will pull it up a bit harder.
The nut is a pain and even a moderate tension on the locking screws caused a strip. Will pull it apart and see what can be done with it, I’ll persist with it until it pees me off enough to change it out completely.

Been through two of the knock off nuts, stripped them both out, so that's why I'm sourcing a proper one for mine too!