Doing more of a mock build to work out scale length for neck placement etc. Looks like neck hard up in pocket will be right given to bridge post routing, which will make setting it easier.

There is a little wiggle room in the pocket, but Looks too small for a side wall shim. Maybe 1mm at the absolute most. I've attached pic below.



Unfortunately one of the bridge posts doesn't fit into the bridge. It is fractionally too small between the lips. Will not fit the bridge on either side. The other post is fine however.



So my previous plan for maybe getting a replacement bridge looks more likely now.... Otherwise I guess I could find out if Adam has a spare post/bushing.