Quote Originally Posted by Sonic Mountain View Post
Have you done any work on the nut end? Although if the bridge is already adjusted all the way down it doesn't seem right.

What does the angle on the neck look like where it deviates from the body?
I have worked the nut set the torsion bar to slightly bow forward 1/64 clearance at the middle of the neck when fretted on the first and last fret. It all looks perfect I had to take <2mm of the bottom of the bridge I used a hack saw then cleaned up with the dremel. It is much better now the only other way would require removing the neck and taking a small wedge out with sand paper to make it lean back more. As I said earlier in the build the neck was a bit of a loose fit not like my LP which was tight. I will keep an eye on it in case it is a neck failure in progress the bridge can not go any lower now or else it will sit the body. I also don't like the way the neck was assembled at the shoulder. a thin piece of mahogany glued to the neck it may be stronger than a single piece but I do not know.