I took this to work last week and dutifully measured all the holes, then measured again to be sure, then drilled them one at a time checking all the while that each piece of hardware fit - not only in the hole but also in relation to all the parts around it. All perfect.
Primed, sprayed, screen printed. Got it home tonight to start wiring it up and... the output cable won't fit in the jack because the 3PDT stomp switch is in the way, and the LED bezel nuts are so close to the corners that they can't be tightened. Of course, I thought I'd checked everything, but...
Luckily I have to more of the same sized enclosures laying around, so back to the drawing board.
On the upside, it looks great with the print. Will try to get a pic tomorrow in better light
Reply With Quote