Yep it's out of bounds now just letting it dry for another week I reckon at least. Sun does blister the finish I put it in the sun for 5 mins and I could see the edges around the back plate holes start to bleed. So no direct sunlight.
Yep it's out of bounds now just letting it dry for another week I reckon at least. Sun does blister the finish I put it in the sun for 5 mins and I could see the edges around the back plate holes start to bleed. So no direct sunlight.
I am afraid this Guitar has dodgy Clear 2k it is still soft. I am going to have to sand it all off and respray with my favorite hard as nails Baslac clear 2k after Xmas. I will do it the same day I spray my ES-3 and P Bass and My red candy Strat which has the same issue it has been curing for 4 years.
So you all know what I am talking about. The finish is cured but if you leave it on a guitar stand it marks the finish where the foam touches the finish over night. If the clear it is not rock hard in 2 days after spraying it will probably never completely cure.
1: FV Circa 1975 Total build from scratch fret board the lot Design out of an Electronics mag. RIP
2: FS Candy Red on Gold Basecoat.
3:Finished Build: LP Custom 3 pickup Black Silver Burst.
4:Current Build SGM-1 Electric Guitar Kit (Mahogany) Going for a nice wood stain effect.
5:Current Build P Bass Electric Guitar Kit (Ash) Going for a nice wood stain effect.
6:Current Build ES-3 Electric Hollow Body Guitar Kit (Sunburst) Going for a nice wood stain effect.
Posting Permissions
Reply With Quote