Hi WazOriginally Posted by wazkelly
Belcat pre amp arrived at work today earlier than expected and have been pondering how you wire it up as there were no instructions or wiring diagram included. This is all I could find on the web......
The red circled bit shows the double stacked blend pot where you wire the hot from each PUP to the centre lug and earth to the same earthed lug on each row. Sounds simple enough and just need to work out which wires do what from the kit supplied PUP.
This is how I'm going to wire my MMB-5 using the same EQ-B2T preamp as you have with the stock kit supplied PUP.
The pull switch puts the coils in series for a meaty rock tone, otherwise it has the same functionality as the Jazz bass parallel (with individual vol) configuration.
This may be an attractive option for you depending on the styles of music you are going to use your bass for. The 250K Bourns switched pot is under $15, so it's a low cost upgrade.
Reply With Quote