no worries Snug you should be able to sand the neck pocket about 1mm wider so the neck heel fits. I am puzzled why the neck screw holes are off centre, so I'm interested to see how the neck plate looks from the bottom of the body being off centre.
When you are testing the neck heel fit, remember to drop it in from above and not slide it in front to rear as the heel is slightly tapered
Current Builds and status
scratch end grain pine tele - first clear coat on !
JBA-4 - assembled - final tweaks
Telemonster double scale tele - finish tobacco burst on body and sand neck
Completed builds
scratch oak.rose gum Jazzmaster - assembled needs setup
MK-2 Mosrite - assembled - play in
Ash tele with Baritone neck - neck pup wiring tweaks and play in
Thank you wokkaboy. I noticed the screw holes were a bit off, this shouldn't be a concern structurally should it? Aesthetically I am not too concerned. I was also wondering in regard to the rosewood neck what is the best way to treat it, there are some minor superficial marks, can I lightly sand then oil the neck?
Posting Permissions
Reply With Quote