Just trying to squeeze the two large Orange Drops (0.047uF and 0.068uF) into the control cavity without interfering with anything else was going to be tough, I still wasn't sure if it was all going to fit.
I'm using 500K pots in the circuit, rather than 250K's like in a J bass, but decided to include a treble bleed to help with potential unintended treble loss. 0.001uF cap and 150K resistor.
Because there are so many connections between the pots and the switch block (11), plus the extra 4-conductor wire to the P pickup, I decided to use some ribbon cable to try to make it a little more manageable. Trying to solder the connections on the mini DPDT's with everything else in the way was challenging. One of the mini DPDT's actually sprung apart while I was working on it… much rage while I reassembled it. But, eventually I seemed to have everything connected correctly… maybe.
Now I need somewhere to put it.
Shielding.
As a cheat I used my routing templates to get the basic outline for the shielding tape.
cont.
Reply With Quote