Hey Ross, I can't remember the pot hole diameter of the standard pots (at a guess about 7-8mm) but it is worth upgrading to better quality pots that will require drilling the holes larger. It is a very easy job, it may end up being about 9/9.5mm diameter so just get a set of drills 1-10mm size in half mm increments.
If you drill slowly from the body top side there is only a small chance of doing damage to the spalted veneer.
Last edited by wokkaboy; 31-01-2017 at 09:04 AM.
Current Builds and status
scratch end grain pine tele - first clear coat on !
JBA-4 - assembled - final tweaks
Telemonster double scale tele - finish tobacco burst on body and sand neck
Completed builds
scratch oak.rose gum Jazzmaster - assembled needs setup
MK-2 Mosrite - assembled - play in
Ash tele with Baritone neck - neck pup wiring tweaks and play in
Posting Permissions
Reply With Quote