SG-2 by Nitroburner1000

[adam]

Yeah, I just had a look through your thread and definitely a bolt on, so we'll send you a plate and 4 screws on Monday. Gold right?

[nitroburner1000]

Yeah, I just had a look through your thread and definitely a bolt on, so we'll send you a plate and 4 screws on Monday. Gold right?

Yes, gold Adam, thanks muchly.

[nitroburner1000]

Hi Nitro/Ads,no the SG-2 is a bolt on neck. The SG-1 and SG-1F are set necks.
Nitro if there was no neck plate and 4 screws included Ads will have to send them out to you.
The photos on page 5 show it is definitely a bolt on neck

cheers for a fast reply wokka, thanks

[wokkaboy]

no worries Nitro, between myself and my 4D buddy Popeye we have built a good percentage of the PBG kits so know them pretty well. All these new models Ads keeps bringing out and bridge upgrades got me keen on a flame tele with Billy Gibbons Babicz bridge !

[nitroburner1000]

no worries Nitro, between myself and my 4D buddy Popeye we have built a good percentage of the PBG kits so know them pretty well. All these new models Ads keeps bringing out and bridge upgrades got me keen on a flame tele with Billy Gibbons Babicz bridge !

Just looking at the teles, they look yum, that will be my next build after the sg..

[stan]

once again outstanding customer service from Adam

[nitroburner1000]

once again outstanding customer service from Adam

Agreed wholeheartedly.

[nitroburner1000]

Just ordered the Warman triple G-Rails and 2 on/on/on mini switches. Im very excited about building this one, im going to try mods that i didnt think id be game enough to try before building the ST-1.

New changes........ Walnut veneer to the body and headstock face, finished in high gloss clear, back, neck and back of headstock stained in golden teak, 2x black triple buckers, part modified pickguard in gold pearl, (already ordered), gold hardware, modified volume and tone controls so i can fit in the mini switches without drilling more holes, moving the main bucker switch to where the les paul guitars have it located, and moving the mono jack to the bottom edge below the tone controls. Gold metal trussrod cover and gold Brian May strings. The mini switches will split the humbuckers.

[wokkaboy]

sounds good Nitro, some pretty big mods you are doing. Should be a wicked axe !

[nitroburner1000]

sounds good Nitro, some pretty big mods you are doing. Should be a wicked axe !

Yes hope so woks, will take my time on this one, do a lot of reading and ask for lots of help again from you guys, so im cutting down the mistakes to a minimum. Although i think half the journey is fixing your mistakes and working out any problems you encounter along the way.