So this gap where the neck meets the body bothers me.
I got a piece of scrap mahogany and started shaping it.
It's taking form. Lost the light before I got it quite all the way there. Still more to do.
I'm going to try and make it follow the same curve as the neck was following before it turned parallel with the body.
(Not the sharp change this image shows, I haven't started on that edge of the piece yet.)
However, since the original has a rounded edge when I place my flat piece on it there will be a small gap. (Or a step before the curve continues, and I don't want a step.)
I'm wondering if the behlen grain filler will set hard enough to bog this or if there is some other putty type thing I should be putting in there to make the transition smooth.
Reply With Quote