Thank you so much for taking the time to put these schematics together.
I play mostly in the Bridge position. So practically, Option 3 was immediately appealing as I'll only need to pull two pots to get into series/out of phase.
Options 1 and 2 were appealing as they feed the bridge into the neck pickup when in Series mode. But, to get from the Bridge only position, I'll need to change the toggle plus pull two pots to get into series/out of phase.
Option 4 is the one I'm most curious to try due to the options on all settings, but I'm not sure how much of those options I would use, practically.
So...
Having said all that, and while I'm yet to set aside any of those options, after considering posts since, a one-switch single fixed series configuration with one pickup out of phase (polarity) may reflect the best outcome for me.
Noting the S1 switch won't fit, and that I would need to drill a hole to the front of the body, would either of these work/fit?
I assume this could be done feeding the bridge into the neck when in series?
And so I can have my cake and eat it too, would it be simple enough to wire this with one push/pull pot that changes the phasing of a pickup? That way, I imagine I could retain the option of out of phase (polarity) in parallel via a push/pull pot, as well as have a one-switch single fixed series configuration with one pickup out of phase (polarity). I assume that if this push/pull pot was engaged with the 4PDT mini toggle you're suggesting, that it would then be in-series/in-phase.
It seems a great solution for in-phase/out-phase/series/parallel with minimal interference by too many pots in the circuit.
Reply With Quote
