Just started work on my DST-1 kit today. I've done my mock build and can see that my neck is out of alignment. I started to sand the pocket on the top side, but as I was progressing I realised that the pocket, heal of the neck and the bridge all have pre-drilled holes.
If all that is pre-drilled, I'm not sure how to do much to change the alignment. If I keep sanding out part of the pocket, it's just going to give me a bigger gap between the neck and the body because it's the pre-drilled holes that will determine exactly where the neck sits.
Any tips on how to adjust the neck or bridge to get the alignment right would be appreciated!
Reply With Quote