Hi guys,
Hope you're OK !

For me, it's a bad time.. I finally survived inserting electronics inside the semi-hollow body, after a very long fight, and I just finish the last step : to glue the neck.

But.. now I'm in big trouble..

My biggest fear comes true : the fingerboard is too high, and I can't tune the strings
Maybe I didn't search enough but I couldn't find anything about this, especially for the ESB4.

So : here's my problem :
Click image for larger version.  Name: IMG_20180417_144704534.jpg  Views: 693  Size: 379.5 KB  ID: 26053

I think I'll have to unglue the neck, sand it a lot to lower it, and glue it again.

Any tips to unglue without damages ?
I think I must find a very long and thin knife, and maybe use some water's steam ?

Thank's !