Hmmm, been a bit slack and didn't realise where the past 2 months went in relation to this baby?
Made a start on the bridge replacement tonight. Removing the old one lifted a bit of finish off that will be obvious just in front of the newer one as it has a much smaller footprint. Old one on the left and newer one on the right which has slots on the back to make string changing a whole lot easier than feeding through tiny holes and risk scraping string across the finish as you draw them through. Feeding them back out was not a lot of fun either so I wont miss the stock kit bridge one bit.
Also had a few holes to fill with bamboo skewers and PVA glue.....the reason why so many holes? It was my 1st build and located the bridge too far across on the treble side initially and had to move across by about 5 mm which was well hidden until doing this modification.
Reply With Quote