Thanks again Waz
Thanks again Waz
Update on the build, nearly finished with the DT, it is an exercise in patience.
DT in cooler weather does take a fair while to go off.
# 1 - EX-5 https://goo.gl/fQJMqh
# 2 - EX-1 https://goo.gl/KSY9W9
# 3 - Non PBG Tele https://goo.gl/W14G5g
# 4 - Non PBG J Bass https://goo.gl/FbBaFy
# 5 - TL-1AR GOTM Aug 2017 https://goo.gl/sUh14s
# 6 - MMB-4 Runner-up GOTM Oct 2018https://goo.gl/gvrPkp
# 7 - ES-1 Runner-up GOTM Aug 2018https://goo.gl/T9BEY8
mmm that's got legs..
FrankenLab:
Turning tone wood into expensive sawdust since 2016!
Finally lost patience with DT top coats, taking way too long to dry properly here in Brisbane. I have now done about 4 coats of wipe on poly in the gloss and very happy with the feel and shine. Need to do a wet and dry cut next and a few more coats to call done. I think I will do the engineered fretboard too, as not overly happy with it.
Looking good.
# 1 - EX-5 https://goo.gl/fQJMqh
# 2 - EX-1 https://goo.gl/KSY9W9
# 3 - Non PBG Tele https://goo.gl/W14G5g
# 4 - Non PBG J Bass https://goo.gl/FbBaFy
# 5 - TL-1AR GOTM Aug 2017 https://goo.gl/sUh14s
# 6 - MMB-4 Runner-up GOTM Oct 2018https://goo.gl/gvrPkp
# 7 - ES-1 Runner-up GOTM Aug 2018https://goo.gl/T9BEY8
Well, life has got in the way of this build, but i am finally in the last stages of wiring, at the end i realised i had neglected to run a wire from the bridge post to earth on the tone pot. Anyone got a good tip on how to remove the TOM posts without damaging the finish? I thought i remembered seeing a post on this but i cant find it.
All sorted now, with a bit of bush engineering and some brute force with a jimmy bar the sleeve was extracted without damage.
Posting Permissions
Reply With Quote