Thanks guys, this is very helpful, with this info I should be able to clean this mess of a nut up haha.
I do have a sanding block with different grits on different sides, would this be okay to...
Type: Posts; User: Mmack089
Thanks guys, this is very helpful, with this info I should be able to clean this mess of a nut up haha.
I do have a sanding block with different grits on different sides, would this be okay to...
Hi everyone,
Got an issue with my nut on my strat. Initially the nut wasn’t cut, the slots were shallow and I had issues when setting up the guitar. The action at the first few frets was really...
Thanks Simon, so I guess I’ll work more on that nut cause yes it still seems high. In terms of the filing, should I be filing it down on a slight angle toward the headstock (the same angle as the...
So I’ve been working on my strat over the last few weeks. I’m at the point of trying to get it set up and playing to a reasonable standard.
In terms of the action, it seems good for most areas of...
Hi, Thanks for your reply.
It seemed like by raising the saddles a bit more (which there actually was still room to do) most of the buzzing was removed which is good. With the truss rod, when...
So I’m trying to set up my ST-1. Initially when I had first put the guitar together, there was a lot of buzzing on all strings and frets, to the point that you couldn’t even ring out a note. At that...
Hi, I’ve recently completed the building aspect of my strat, I’m at the point of setting up the guitar. I’ve watched a couple of the videos on adjusting the bridge saddles and intonation.
With...
Thanks for your replies, I’ve taken photos of the bridge. Most of the saddle screws are screwed in about halfway down the hole, it doesn’t seem it will get much higher. Most of the strings seem to...
Hi there,
So I’m at the stage where all hardware parts have been attached apart from the string trees. Will attach these once strings are on so they are lined up in exact position. So I’m...
Haha, yes I did, would like to take the sole credit for doing that but actually had some assistance with the finish.
So I guess “like a real man” I took a smoko break early into the project...
Cheers Guys, I managed to find the wiring diagram as well and turns out the yellow wire is the hot wire while the two black ones are ground, I did the same thing as the guy in the other thread, by...
Hi I’m having trouble understanding which wire is to be soldered to the output jack and which wire to the claw on the bridge. The kit came with the controls and pickups pre wired. There are two black...
Thanks Guys, that’s been very helpful In getting this under way.
Hi All,
Doing my first Pitbull Kit, the ST-1 which I received as a birthday gift. The paint finish is complete (as pictured) I’m just having trouble understanding where to start on the build. I...