That's correct- maple neck / mahogany body.
I am not 100% on this, but I was considering the Stew Mac Aerosol finishing set in gloss black. I'm also contemplating an air brush set up as I do have...
Type: Posts; User: SGHunter
That's correct- maple neck / mahogany body.
I am not 100% on this, but I was considering the Stew Mac Aerosol finishing set in gloss black. I'm also contemplating an air brush set up as I do have...
@johnwhitear the scale length and spacing check out. The neck has a convex bow to it but according to the PB instruction guide that is normal and I was going to wait to straighten and level the frets...
I am looking for some advice. I shaped the nut similar to the plastic one that is included, but I think its going to end up being far too tall.
- Should I take more off the nut now or should I...
I took care of the nut situation. PB is going to refund me and I got a blank and I am fitting a new nut. At this point I have it mostly shaped and slotted but I wanted to find out if I should do or...
Thanks as always for the advice.
Holes have been taken care of and the controls mocked up. I put the 4 way switch as far over as I could given the cavity and it just barely results in a little...
I used tape to get the bridge fitted and used the string method described above and the spacing looked good. However, I ordered a bone nut with the kit which it came with, but it is right handed. I...
@RocknRolf, @Trevor Davies, @Simon Barden -
Thank you all for the replies. I went ahead and ordered a harness with consideration for the location of the jack and it is being made with extended...
Hello everyone,
New member from the USA here, starting my first build. I am a lefty and a big fan of Gibson EB/SG basses and I was thrilled to see Pit Bull offered a kit with that style of body...