Search:

Type: Posts; User: SeanP31

Search: Search took 0.00 seconds.

  1. Replies
    6
    Views
    26,246

    Well, i am going the simple route of filing the...

    Well, i am going the simple route of filing the holes a bit bigger to make it sit and it has worked so far to get the 6 string bridge to sit. now I am trying to figure out neck angle that isn't...
  2. Replies
    6
    Views
    26,246

    True. Sadly, the holes are drilled too close...

    True. Sadly, the holes are drilled too close together so the bridge doesn't fit on the post holes. Again, during the mock build they sat fine without fully putting the posts in, which was a mistake...
  3. Replies
    6
    Views
    26,246

    Thanks Simon, makes total sense. Feel dumb that I...

    Thanks Simon, makes total sense. Feel dumb that I didn't notice this myself.

    I managed to match the bridges with the posts and the the tailpieces with the bridges. The notched wheel posts matched...
  4. Replies
    6
    Views
    26,246

    Bridge and TailPiece Posts - Different Sizes!

    Getting ready to put in the posts for the bridge and tailpiece on my double neck SG style, and I see that there are different posts, 2 of each. The tailpiece post, the screw is thicker on on two of...
  5. Replies
    3
    Views
    1,132

    Thanks for the replies, gents. This is only my...

    Thanks for the replies, gents. This is only my second build (first was a tele style and super easy to wire) so the double neck with the three switches has required a lot of research and watching...
  6. Replies
    3
    Views
    1,132

    Double Neck Pick up volume

    Just wired my SG style double neck and the pickup volume on the 12 string side is much louder than the pickup volume on the 6 string side. Is that a wiring or grounding issue? not sure what could...
Results 1 to 6 of 6